Adding an Elevator

1. From the left navigation pane, click Hardware.

2. From the top navigation bar, click Profiles.

3. In the Hardware Profiles page, find and select the site profile to which you wish to add a device.

4. Click Edit on the profile tile. You can also click and select Edit from the list.

5. In the Edit Profile page, click the Configurations tab.

6. Go to the Elevator section, then click New Elevator.

7. On the Add New Elevator page, complete the details.

   Field	Description
   Name	Enter a unique and meaningful name. The name should contain only alphanumeric characters and no spaces. Up to 255 characters can be used.
   Description	Enter more information about the device.
   General
   Logical ID	Enter a unique identifier for the device connected to the S1000 Controller. Allowed range is 0-254.
   Reader	Click + to find and select the reader associated with the elevator.
   Secondary Reader	Click + to find and select the secondary reader associated with the elevator.
   Reader Schedule	Click + to find and select the schedule for the reader associated with the elevator.
   Card and PIN Schedule	Click + to find and select the card and PIN schedule for the reader associated with the elevator.
   Card or PIN Schedule	Click + to find and select the card or PIN schedule for the reader associated with the elevator.
   Output On Duration (sec)	Enter the time in seconds for the output on duration.
   Reporting
   Report Events	Turn on the toggle to record events.
   Report To	Select the connection paths where the recorded events will be reported. Select the checkbox next to the option on the drop-down list or select the Select All checkbox.
   High Priority	Turn on the toggle to assign high priority to this device.
   Floors
   Add floor	Click to enter the details about the floors associated with the elevator. Click + on Floor to find and select the floor profile. Click + on Input to find and select the associated input. Click + on Output to find and select the associated output.
   Clear all floors	Click to remove any and all floors associated with the elevator.

8. Click Create.