Adding a Pulse Counter

It is possible to add up to 32 pulse counters, if needed.

A pulse counter will count up to 65535, then count down to 0 and repeat once 0 is reached.

1. From the left navigation pane, click Hardware.

2. From the top navigation bar, click Profiles.

3. In the Hardware Profiles page, find and select the site profile to which you wish to add a device.

4. Click Edit on the profile tile. You can also click and select Edit from the list.

5. In the Edit Profile page, click the Configurations tab.

6. Go to the Pulse Counter section, then click New Pulse Counter.

7. On the Add New Pulse Counter page, complete the details.

   Field	Description
   Name	Enter a unique and meaningful name. The name should contain only alphanumeric characters and no spaces. Up to 255 characters can be used.
   Description	Enter more information about the device.
   General
   Input Logical ID	Enter a unique identifier for the device connected to the S1000 Controller.
   Device	Click + to find and select the device.
   Physical ID on Device	Enter the unique identifier configured for the device.
   Area	Click + to find and select the area where the device is located. By default, the area with the lowest logical ID in the site profile is selected.
   Minimum Pulse (ms)	Enter the minimum pulse value that the counter is allowed.
   Polarity	Click + to select from Low or High polarity.
   Pull Up Resistor	Toggle OFF or ON to enable a pull up resistor.
   Reporting Frequency (s)	Enter the time in seconds of how often reporting occurs.
   Pulse Count	Enter the value of the pulse count.
   Reporting
   Report Events	Turn on the toggle to record events.
   Report To	Select the connection paths where the recorded events will be reported. Select the checkbox next to the option on the drop-down list or select the Select All checkbox.
   High Priority	Turn on the toggle to assign high priority to this device.

8. Click Create.