Adding a Sensor Board

1. From the left navigation pane, click Hardware.

2. From the top navigation bar, click Profiles.

3. In the Hardware Profiles page, find and select the site profile to which you wish to add a device.

4. Click Edit on the profile tile. You can also click and select Edit from the list.

5. In the Edit Profile page, click the Configurations tab.

6. In the Devices section, click New Device then select Sensor Board from the drop-down list.

   The Add New Sensor Board wizard displays.

7. On the Select Template page, choose the Default Template.
8. Click Next.

9. On the Add Sensor Board page, complete the details.

   Field	Description
   Name	Enter a unique and meaningful name. The name should contain only alphanumeric characters and no spaces. Up to 255 characters can be used.
   Description	Enter more information about the device.
   General
   Logical ID	Enter a unique identifier for the device connected to the S1000 Controller. Allowed range is 0-254..
   Serial Port	Click + to find and select the appropriate serial port. Available options: Onboard Isolated - the board is using the PL4-PL5 connection on the S1000 Controller. Onboard Non-Isolated - the board is using the PL5-PL6 connection on the S1000 Controller.
   Device Loop Address	Enter the numerical value of the DIP switch.
   Area	Click + to find and select the area where the device is located. By default, the area with the lowest logical ID in the site profile is selected.
   Reporting
   Report Events	Turn on the toggle to record events.
   Report To	Select the connection paths where the recorded events will be reported. Select the checkbox next to the option on the drop-down list or select the Select All checkbox.
   High Priority	Turn on the toggle to assign high priority to this device.

10. Click Next.
11. On the Create Additional Points page, tick the checkbox next to the listed analog inputs and outputs that will be associated with the sensor board.
12. Click Create.