Input Configuration For PowerG Devices

The following table provides the inputs configurations for all PowerG devices supported by the S1000 Controller.

Note: PowerG wireless sensors are programmable, and Sensor Category must be configured in Sonitrol CORE to trigger the correct alarm type, as the default Category in Sonitrol CORE may not match the sensor’s intended use.

Device Part Number	Device Description	Input Type	Input Physical ID	Input Description
PG9303	Wireless Contact	Digital	1	Magnetic contact Open/Closed
PG9945	Wireless Contact + Wired Contact	Digital	1	Magnetic contact Open/Closed
PG9945	Wireless Contact + Wired Contact	Digital	2	Wired contact Open/Closed
PG9938	Panic key with one button	Digital	1	Panic button pressed (does not send change of state)
PG9949	Panic key with two buttons	Digital	1	Button 1
		Digital	2	Button 2
		Digital	3	Both Buttons 1 and 2 for more than 3 seconds
PG9914	Pet-immune PIR motion detector	Digital	4	Motion detection
PG9872	Long range 360° Ceiling-mount PIR detector	Digital	4	Motion detection
PG9862	Ceiling-mount PIR detector	Digital	4	Motion detection
PG9922	Two-way glass break detector	Digital	10	Glass break detection

See Also

Wiring

Adding a PowerG Host to the S1000

Adding a PowerG Host in Sonitrol CORE Adding a PowerG Wireless Device in Sonitrol CORE

Enrolling PowerG Devices

PowerG Devices Enrollment Methods

Documentation Reference SONCORE_12_2-UG-EN-1_0 created February 2026 applies to SONITROL CORE v12.2