Aperio Devices
Sonitrol CORE and the S1000 Controller integrate with ASSA ABLOY Aperio devices. Multiple Aperio devices can communicate with one or more AH-30 Hubs using short distance wireless communications. The hubs communicate with the S1000 Controller using the RS485 serial data connection.
There is no limit to the number of existing doors that can be secured with Aperio devices. Aperio integrates with most units and systems, due to it being developed based on an open standard.
Refer to the ASSA ABLOY documentation for details on their products.
- S1000 Controller firmware v1.2.7 and later
- ASSA ABLOY Hub firmware version 3.7.1.3447 or later
- ASSA ABLOY PAP tool
- Aperio Programming Application 18.0
The following Aperio devices connect wirelessly to the AH-30 Hub and can be used with the S1000 Controller:
- AU100 V3 Escutcheon
- C100 Knob Cylinder
- E100 V3 Escutcheon
- H100 Handle
- K100 Cabinet Lock
- P100 Padlock
The Aperio devices must be configured using the ASSA ABLOY PAP tool, Aperio Programming Application 18.0 according to the following guidelines:
|
Aperio |
For the field ... |
Select or enter ... |
|---|---|---|
|
Hub |
EAC Addressing Offset |
Legacy or normal mode |
|
Status Report Interval |
5 minutes |
|
|
Devices |
Disable credential cache |
Static/dynamic |
|
Clear all credentials in lock |
|
|
|
Devices with PIN PADS (for example, AU100) |
Set PIN to terminate on unlock key (no PIN length) |
|
|
Status Report Interval |
5 minutes |
|
|
Poll Interval |
5 seconds |
|
|
Sensor Events for those locks with inbuilt sensors |
Enable handle sensor Enable handle detection |