Adding an Inovonics Environmental

1. Log on to the Sonitrol CORE.
3. From the left navigation pane, click Hardware.

4. From the top navigation bar, click Profiles.

5. In the Hardware Profiles page, find and select the site profile to which you wish to add a device.

6. Click Edit on the profile tile. You can also click and select Edit from the list.

7. In the Edit Profile page, click the Configurations tab.

3. Go to the Device section, click New Device then select Inovonics from the drop-down list.

   The Add New Inovonics wizard displays.

4. On the Select Template page, choose the Default Template.
5. Click Next.

6. On the Add Inovonics page, complete the details.

   Field	Description
   Name	Enter a unique and meaningful name. The name should contain only alphanumeric characters and no spaces. Up to 255 characters can be used.
   Description	Enter more information about the Inovonics Environmental.
   General
   Logical ID	Enter a unique identifier for the device connected to the S1000 Controller. Allowed range is 0-254.
   Area	Click + to find and select the area where the device is located.
   Product Type	Click + to find and select Environmental.
   Product Model	Click + to find and select the environmental model.
   Serial Number	Enter the serial number of the Inovonics Environmental. The serial number is usually found on a sticker on the device or inside the cover.
   Parent	Click + to find and select Controller as the parent.
   Serial Port	Click + to find and select Onboard Isolated as the serial port.
   Signal Change	Use the default signal change of 5dB.
   Signal Minimum	Use the minimum signal of 50dB.
   Offline Timeout	Use the default offline timeout of 360 seconds. This is approximately 5 minutes including a small margin. These devices will check-in every 5 minutes, unless there is a significant measurement of change.
   Reporting
   Report Events	Turn on the toggle to record events.
   Report To	Select the connection paths where the recorded events will be reported. Select the checkbox next to the option on the drop-down list or select the Select All checkbox.
   High Priority	Turn on the toggle to assign high priority to this device.

   Tip: There is a programming cable for certain Inovonics Transmitters that allows you to set parameters such as the sample time, check-in, temperature change to report on, etc. This can help you with radio traffic as you can push out check-ins.
7. Click Next.

8. On the Create Additional Points screen, click Create.

   If applicable, Sonitrol CORE automatically creates the associated inputs.